We use own and third party cookies to offer our services and to collect stadistical data. Continue browsing implies acceptance.More informationAccept
< Back

Pit Box

Epsilon pit control unit

Epsilon pit control unit

Reference: MWA019
• Inspection control station embedded with the car roof station.
• Pre-wiring for lifts of reduced pit.
• Suitable for installation of Konbox® shaft
• Flood sensor to avoid electrical damages and capture of persons in the car.
• Optional to include seismic sensor.

DESCRIPTION
new elevator pit station A019 fulfills the Standard EN81- 41 and in its design has been taken into account the inclusion of all the components that can be required from high-end elevator to small “homelifts”.
It’s based on the use of the CAN bus as an extension of the external station. It makes an efficient and safe locking of the movement functions in inspection movement, forcing the coordination with the car roof station.
Its box is watertight in all the surfaces except the base, where it concentrates all the input/outputs of the wires, which gives a protection degree IP33 (Protection to the entrance of solids >2,5 mm and water projections until 60º from the vertical).
It has water detector so in case of flood. Force the stop of the car in the closer floor and/or to not allow the start of a new trip. When the car is in a floor level and with the open door, the same detection forces the opening of the relay of offshoot to the ground and inhibits the automatic rescue.
As an option it’s supplied with the triaxial seismic sensor incorporated, with LED status indicators, automatic self test, local reset button and battery for up to 2 years of monitoring in the case of absence of network. The integration into the pit station represents the best technical and economical option, since it requires no installation or additional wiring.
Share  
You may also like

About us


SmartLift is the leader designing and manufacturing electronic solutions for elevator market



SEE MORE

Subscribe to our newsletter

Last news

  • Delta+ controller, all features with a minimum wiring

    Delta+ controller meets the most demanding requirements in high range lifts. It has been designed paying attention to every detail to minimize external connections and reduce wiring to the maximum, saving space and avoiding errors. This plug and play control unit is complete with all lift functions and modules, shortening the panel manufacturing and set-up time. Delta+ guarantees an optimized installation offering a reliable system able to speed up performance and reduce costs. SEE MORE
  • Innovative electronics for smart buildings

    The innovative MW9809 lift controller is the perfect solution for any modernization on your elevator system. Using a technology with totally programmable microprocessors and a minimum wiring, MW9809 merges advanced engineering with costs optimization to create your smart and high performing control module for a safe, efficient and modern lift. SEE MORE

 
SEE MORE